Pool Liner Replacement
Installing a new vinyl liner for your pool is fast and easy and takes very little technical skill. Installing the liner is actually quite easy in terms of a DIY project especially considering how much money you can save over the course of one weekend. Being a commercial vinyl pool liner installer is a more difficult process since you will need to be required to have knowledge outside of what it takes to install the liner itself, and are held accountable for each liner installation to be cosmetically perfect.Visit this website pool liner repair cost.
Installing three liners per week without any wrinkles or problems requires years of experience in the trade. Installing a single liner, in your own pool, for the expressed benefit of saving thousands of dollars is easy by comparison. The most likely problem that you can encounter when installing your own liner is to have wrinkles on the floor and slopes. Even if the liner is sized well you can still easily have wrinkles in your liner if you do not have the ability to diagnose the problem and adjust the liner accordingly. A professional installer uses experience to orient the liner for the best fit possible where you will just wing it based upon what you see at the time. In a worst case scenario you are not able to lose all the wrinkles and have to live with the results. The real benefit here is that as long as you are satisfied with the results, then the project was successful since wrinkles are cosmetic and do not compromise the pools ability to hold water.
Tools You Will Need:
Utility knife with extra blades
Garden hose and nozzle
Paint scraper / flat metal edge
5 Horsepower residential wet / dry vacuum
Stiff bristle shop broom
Soft bristle shop broom (optional)
Phillips screwdriver, medium
Phillips screwdriver, large
100′ flexible tape measurer (sometimes two of these)
These items are all so common that hopefully you will have them already or be able to borrow them from friends and family. If you do not have any of these tools and can not borrow them from anyone you know you, you can rent them from a hardware store for less than buying them will cost. On a personal note, if you can not pull together items like a screwdriver, broom, kettle and garden hose from everyone you know put together you should consider throwing a pool party when you finish your liner and attract some new and more diverse acquaintances.
Materials You Will Need:
30 mil vinyl liner with a dark print (border optional but recommended)
25 wooden clothes pegs separated, spring removed
2 full rolls standard duct tape
1 can of wd40 penetrating oil
1 can galvanized steel rust paint
1 can galvanized steel primer (optional)
New skimmer gasket & faceplate
New returns gasket & faceplate
Fine washed sand (depending on floor condition)
Vermiculite or zonolite (depending on floor condition)
Type 10 / type 1 portland cement (depending on floor condition
Measuring the Pool
The first step you will need to take is to measure your pool for a new liner which will be manufactured and shipped to you. This process can take a little as two weeks in the off season or as much as six weeks or more during the spring and summer season. Measuring the liner involves following a template supplied by the company that you order your liner from. The liner measurement template will be specific to the shape of your pool and will take into account length, width, orientation and corner radius.